Breath-A-Tech Anti-Static Collapsible Spacer

Directions

1. Pull both ends of the spacer, then twist the top section until you hear a click. Ensure the extension of the sapcer is secure before use.
2. Before use check for any foreign objects, broken or deteriorated parts.
   Replace the Breath-A-Tech Anti-Static Collapsible Spacer immediately if any damage or missing parts are evident.
3. Prepare the puffer by following the instructions provided with your medication.
4. Ensure the cap from the puffer has been removed. Push the puffer into the end cap base of the Breath-A-Tech Anti-Static Collapsible Spacer.
5. Pull the spacer mouthpiece between your lips and make an airtight seal.
   Depress your puffer and you will see a fine spray inside the Breath-A-Tech Anti-Static Collapisble Spacer.
   Breath in and out through the spacer for 4-6 breaths or follow the instructions provided with your puffer, or as directed by your healthcare professional.
   Alway follow the instrucions provided with the puffer or your asthma/COPD action plan on how long to wait before repeating this step. Only use one dose from the puffer at a time.
6. After use, close the extension of the Breath-A-Tech Anti-Static Collapsible Spacer by holding both ends of the spacer and twisting the top section until you hear a click. Push both ends of the spacer together to collapse.
   Store in a clean, dry place, away from direct sunlight.

Cleaning Instructions

DISASSEMBLING YOUR SPACER FOR CLEANING.
To extend the device, pull both ends of the spacer, then twist the top section until you hear a click.
Remove the end cap base by placing your thumb in the hole, and pulling the ewnd cap simultaneously.
Do not remove the mouthpiece and silicone valve.

Diswashing Method
The Breath-A-Tech Anti-Static Collapsible should be cleaned weekly in a dishwasher, up to 70°C.
Place the end cap base and the sapcer on the top shelf of the dishwasher. Position the end cap base flat.
Place the spacer in an upright position in the dishwasher, with the mouthpiece facing up.

Handwashing Method
The Breath-A-Tech Anti-Static Collapsible should be cleaned at least once a week.
Do not use a brush or an abrasive sponge to clean the Breath-A-Tech Anti-Static Collapsible Spacer, particularly near the valve area, as this can damage your spacer.

1. Wash both parts in warm water with a dishwashing liquid.
2. Rinse both parts in clean water.
3. Shake  off any excess water and allow both parts to air dry in a vertical position, with the mouthpiece facing up.

ASSEMBLING YOUR SPACER AFTER CLEANING
When both parts of the Breath-A-Tech Anti-Static Collapsible Spacer are completely dry, firmly replace the end cap base by pushing onto the spacer. Close the extension of the spacer by holding both ends of the spacer, then teist the top section until you hear a click.
Push both ends of the spacer together to collapse.

Warnings

Ensure Instructions for Use have been read prior to use and are kept available at all times.
Always follow the instructions provided with your puffer.
Ensure the spacer is fully extended and locked into position prior to use.
Children must be supervised by an adult or caregiver during use.
If breathing problems or symptoms persist, contact your physician and seek prompt medical attention.

REPLACE WITHIN 12 MONTHS OF FIRST USE

Note: the Breath-A-Tech Anti-Static Collapsible Spacer may be disposed of in general waste.